Toshiba HD-XA1KN Service Manual page 30

1-2-6. Front PC Board
1. Remove the top panel and top cover. (Refer to item 1-1-1.)
2. Remove the front panel. (Refer to item 1-1-2.)
3. Disconnect the connector (1), remove two screws (2), and then remove the gear assy (3).
4. Remove eight screws (4), then remove the front main PC board (5).
5. Remove four screws (6), then remove the PWR-SW PC board (7).
6. Remove two screws (8), then remove the DOOR-DETECT-SW PC board (9).
7. Remove two screws (10), then remove the USB PC board (11).
8. Disconnect the flexible cables (12) and (13) and connectors (14) to (16).
Note:
• When installing the Door-Detect-SW board, orient it correctly.
Be sure to connect the connector
with a mark to the USB PC board
when reassembling.
Connector (14)
Screws (8)
DOOR-DETECT-SW
PC board (9)
Front panel (1)
Screws (6)
PWR-SW
Flexible cable (13)
PC board (7)
Screws (10)
USB PC board (11)
Connector (15)
Fig. 2-1-12
Front main PC board (5)
Flexible cable (12)
Screws (4)
Connector (16)
Screws (2)
Connector (1)
Door open/
close drive (3)