C. Front panel (door and open/close key) (HD-XA1)
Check that insulating tape is stuck on the back of the door and open/close key on the front panel when reassembling.
D. Arranging ground wire (between USB board and AV board)
Fasten the ground wire together with other wires using a cable tie to keep it away from the primary circuit of the power
board.
E. Shaft brackets of electric door (HD-XA1)
Check that gaskets are attached to the shaft brackets of the electric door at the lower part (right and left sides) on the
back of the front panel when reassembling.
Fig. 2-2-6
Fig. 2-2-4
Fig. 2-2-5
Fig. 2-2-7