Electrical Connection - Miele G 7883 Operating Instructions Manual

Electrical connection

,
All electrical work must be
carried out by a suitably qualified
and competent person in strict
accordance with current local and
national safety regulations.
– If the machine is connected via a
plug and socket, the plug connection
must be easily accessible. Plug
connection will also make it easier to
carry out mandatory safety checks,
e.g. after commissioning or
maintenance.
– For hard-wired machines connection
should be made via a suitable
isolator, with an on-off switch which
is easily accessible for servicing and
maintenance work after the machine
has been installed. An electrical
safety test must be carried out after
installation and after any servicing
work. When switched off there must
be an all-pole contact gap of at least
3 mm in the mains connection
switch.
– For extra safety it is advisable to
protect the machine with a 30 mA
residual current device (RCD).
Contact a qualified electrician for
advice.
– The mains connection cable may
only be replaced by an original Miele
spare part or an appropriate cable
with wire end ferrules.
– For technical data see data plate or
wiring diagram supplied.
68
The machine must only be operated
with the voltage, frequency and fusing
shown on the data plate.
This machine can be converted in
accordance with the conversion
diagram and wiring diagram supplied.
The data plate with test certification is
on the rear of the machine and also
behind the plinth panel on the
protective plastic cover.
The wiring diagram is supplied with
the machine.
See also the installation diagram
supplied.
Bonding connection
There is a screw connection point
marked with the earth symbol (
the back of the machine, to which the
earth lead must be connected.
WARNING
THIS APPLIANCE
MUST BE EARTHED
8
) at