Miele G 7883 Operating Instructions Manual page 57

Fault
The programme is
cancelled and the
"Fill/Drain" indicator
flashes.
Water in the wash
cabinet is not heated;
the programme lasts
too long.
Possible cause
Fault code F..A:
There is a water drainage
fault.
Fault code F01 - F03,
F18, F19, F27
This machine has a
resettable heater limiter
which will switch off the
heating elements if they
over-heat. This could be
caused, for example, by
large articles covering the
heating elements or if the
filters in the wash cabinet
are blocked.
Problem solving guide
Remedy
Before trying to rectify the
problem, you must:
– Turn the programme
selector to f (the fault
code goes out).
– Switch the machine off with
the "On/Off" switch.
– Clean the filters in the
wash cabinet.
– Clean the drain pump.
– Clean the non-return valve.
– Remove any kinks and
straighten the drain hose.
Then:
– Switch the machine on.
– Drain the water.
– Start the programme
again.
To rectify the problem:
– Clean the filters in the
wash cabinet.
– Rearrange the load.
– Reset the thermal cut-out
(see "Other problems,
Thermal cut-out").
57