Intended Use; Technical Data; Declaration Of Conformity; Troubleshooting - Bosch AMW FS Original Instructions Manual

OBJ_DOKU-44516-002.fm Page 13 Monday, March 30, 2015 11:54 AM

Intended Use

This multi-tool attachment can only be operated by the power
unit AMW 10.
The machine is intended for cutting of grass,light and heavy
vegetation, brambles and bushes in domestic and hobby
gardens.

Technical Data

Brush Cutter Attachment
Article number
No-load speed
Cutting width
Weight according to
EPTA-Procedure 01/2003
Serial number
Please observe the article number on the type plate of your garden
product. The trade names of the individual garden products may vary.
Noise/Vibration Information
The following information is applicable for the attachment
operated by the power unit.
Sound emission values determined according to
EN 50636-2-91.
Typically the A-weighted noise levels of the product are:
Sound pressure level 88 dB(A); sound power level 99 dB(A).
Uncertainty K =1 dB.
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 50636-2-91:
2 2
a =3.0 m/s , K=1.8 m/s .
h

Declaration of Conformity

We declare under our sole responsibility that the product
described under "Technical data" in combination with power
unit AMW 10 (3 600 HA3 0..) is in conformity with all relevant
provisions of the directives 2011/65/EU, until 19 April 2016:
2004/108/EC, from 20 April 2016 on: 2014/30/EU,
2006/42/EC, 2000/14/EC including their amendments and

Troubleshooting

Problem
Motor runs but blades remain
stationary
Machine does not cut
Bosch Power Tools
complies with the following standards: EN 60335-1,
EN 50636-2-91.
2000/14/EC: Guaranteed sound power level 100 dB(A).
Conformity assessment procedure according to Annex V.
Equipment category: 33
Technical file (2006/42/EC, 2000/14/EC) at:
Bosch Lawn and Garden Ltd., PT-HG/ENS-PA2,
Stowmarket, Suffolk IP14 1EY, England
Henk Becker
AMW FS Executive Vice President
Engineering
3 600 HA3 E00
-1
min 8000
cm 23
Robert Bosch GmbH, Power Tools Division
kg 1.6
70764 Leinfelden-Echterdingen, GERMANY
30.03.2015
see type plate on the gar-
den product
Mounting and Operation
The numbering of the figures refer to the illustrations of the
machine on the graphics page.
Action
Delivery scope
Mounting the blade guard
Attaching the blade
Disassemble the handle
Mounting the barrier/operating ad-
vice for right-handers
Mounting the barrier/operating ad-
vice for left-handers
Fitting the multi-tool attachment
Attaching the shoulder strap
Working advice
Cleaning
Storage
Selecting accessories
Possible Cause
Multitool-attachment not properly
connected to power unit
Cutting blade damaged
English | 13
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Figure
1
2
3
4
5
6
7
8
9
10
11
12
Corrective Action
Check for correct assembly
Replace the blade (always wear protective
gloves)
F 016 L81 232 | (30.3.15)
Page
201
201
202
203
203
204
204
205
205
206
206
206