Maintenance; Replacing The Fuse - SCANVIEW ScanmateF8+ Operator's Manual

Replacing the fuse

The fuse is located in a holder in the power socket assembly at the back of
the scanner. To change the fuse, proceed as follows:
1 • Switch off the scanner and unplug the power cable.
2 • Using your fingernail or a screwdriver, pull open the fuse holder and flip
it outwards.
Fuse holder
3 • Replace the fuse with a new fuse of the same type and rating (T-4A high
breaking capacity).
CAUTION: Use only the specified type of fuse.
4 • Flip up the fuse holder and push it in until it locks in place.
5 • Reconnect the power cable.
ScanMate F6 / ScanMate F8 Plus • Operator's Manual

MAINTENANCE

5•1