Table of Contents
Advertisement
ISIS iQ UNO Pump Parts Guide
All you need to assemble and use ISIS iQ UNO is shown here. If any of the parts are missing,
or if you have any questions, please contact Customer Services (see back page for details).
Pump Parts
a
b
h
g
c
d
e
i
f
j
2
Bottle Parts
Control Handle
– adjusts the pumping suction, speed
and pattern so ISIS iQ can learn and
then repeat your rhythm after only 2
compressions.
k
Power socket
l
Control button
– turns pump on and
m
off and automates
your pumping rhythm.
Control handle
n
o
Battery Pack
a
1x Control handle
b
1x Silicone diaphragm
Power
with stem
cable
c
1x White valve
d
1x Pump body
e
2x Milk container
(1x 125ml/
4oz and 1x 260ml/9oz)
1x Stand
f
(same as
h
)
g
1x Let-down Massage
Only the following batteries are
Cushion
compatible with the ISIS iQ UNO
Battery Pack: Duracell Ultra M3,
h
1x Funnel cover
(same as
f
)
Duracell Plus, Energizer Ultra Plus,
i
1x Battery pack
Duracell Accu (NiMH),Ansmann
j
1x Mains power lead
(NiMH). For Duracell Acc (NiMH)
& Ansmann (NiMH) use/charge in
k
1x Dome cap
accordance with manufacturers
l
1x Extra Soft, Newborn
guidelines. Dispose of batteries as
Flow Teat
per manufacturers instructions.
(0m+)
2x Screw ring
m
n
1x Sealing base
o
2x Sealing disc
ISIS iQ UNO Pump Parts Guide – Detailed
NEVER STERILISE OR IMMERSE IN WATER
Mains Power Lead
NEVER STERILISE OR IMMERSE IN WATER
Avoid contact with antibacterial or abrasive detergents/cleaners
°
as they can damage the plastic. Combinations of detergents,
cleaning products, sterilising solution, softened water and
Cracking or
temperature fluctuations may, under certain circumstances, cause
discolouration
the plastic to crack. If this occurs, do not use.The pump body and
of pump parts
breast milk containers are dishwasher safe but food colourings
may discolour them. Follow guidelines in 'Cleaning and Sterilising
ISIS iQ UNO' on page 6.
Light
Use the spare parts included with your ISIS iQ UNO or contact
°
Lost or damaged parts
Philips AVENT for replacements (see back page for details).
Ensure the pump is correctly assembled and switched on
°
with the power indicator illuminated
Make sure the lead between the electrical wall socket
°
Pump not responding
or battery pack and the pump is correctly connected.
If using the battery pack, use recommended batteries and
°
check they are inserted correctly.
3 flashes, delay, 3 flashes etc – if the pump stops working and the
°
power light is flashing
Disconnect the power and check the control handle and diaphragm
Pump light
for obstructions or damage.
flashing
RED
Continuous
RED
°
You should consider replacing the batteries.
The pump must be switched off via the control button in order
°
to separate these parts. If the batteries go flat mid-pumping, you may
experience difficulty. Replace the batteries or connect the pump to an
electrical socket.Turn the pump on by holding down the control
Difficulties in separating
button until the light flashes
the control handle from
on (this can take up to 5 seconds).When the light turns to solid
the pump body
GREEN, press and hold the control button again, to turn the pump
off.The light will go out and you can now disconnect the pump from
the power supply and separate the parts (refer to 'Disassembling ISIS
iQ UNO' on page 5).
Need Help? Contact Customer Services (see back page for details)
3
Troubleshooting Guide
GREEN.
RED
the pump has detected a vacuum fault.
pulsing flash – Low battery warning.
ORANGE
and you hear the pump turn
20
Advertisement
Table of Contents
