Philips SCF250 User Manual page 8

ENGLISH
8
- The dimensions of the bottle or the material of the bottle (glass in
stead of plastic) may influence selecting the correct knob setting.
Therefore always control the end temperature and adjust the
setting of the knob.
Warning!
When you leave the bottle in the bottle warmer after it is heated up,
the temperature might increase a few degrees.
Warming baby food jars
Turn the click-step control knob 4 to the left to the "." (OFF)
1
position.
2 Connect the bottle warmer to the mains socket.
The indicator lamp lights green.
3 Remove the label and lid from the jar.
4 Fill the beaker with 20ml water by using the water cup of the
ring.
5 Place the jar in the middle of the container and put the ring on
top of it.
Set the click-step control knob to the n symbol.
6
The indicator lamp lights red.
When the right temperature is reached the indicator lamp will light
green.
7 Remove the jar from the container and turn the control knob to
the left to the "." (OFF) position.
8 Stir the contents of the jar to distribute the heat.
9 Always check that the contents of the jar are at the correct
temperature by testing some on the back of your hand or via
your mouth.
10 If the temperature is much too low, fill the beaker again with
10ml.Turn the click-step control knob 4 to the right until the
indicator lamp lights up red to start the heating up again.