Philips SCF250 User Manual page 7

Unreel the required cable length from the cable reservoir 8 and
3
plug into the mains outlet.
Operation
Warming of baby bottles
Turn the click-step control knob 4 to the left to the "." (OFF)
1
position.
2 Connect the bottle warmer to the mains socket.
The indicator lamp lights green.
3 Fill the beaker with 10 or 20ml water by using the water cup of
the ring 6.The content is depending on the bottle filling and
start temperature (see Heating Overview on page 100).
Place the bottle in the middle of the beaker and put the ring 6
4
on top of it.
Use the click-step control knob 4 to set the correct setting
5
(see Heating Overview on page 100).
The indicator lamp lights red.
When the right temperature is reached the indicator lamp will light
green.
6 Remove the bottle from the container and turn the control knob
to the "." (OFF) position.
7 Shake the bottle a little to distribute the heat evenly before you
allow your baby to drink.
8 Check that the contents of the bottle are the correct
temperature by pouring a few drops on the back of your hand.
Notes!
- The ring ensures that the hot steam heats up the bottle extremely
fast to the right temperature.Warming the bottle without the ring,
might result in a wrong temperature, therefore never use the bottle
warmer without the ring.
ENGLISH
7