ROUTINE MAINTENANCE
Removal of attachments
Note:
Take care not to damage the UV lamp (when an optional UV system kit MCO-18UVS2 is installed) or
water level sensor at the time of removal or replacement of attachments.
1. Close the valve of the gas cylinder and turn off the power.
2. Open the outer and inner door.
3. Pull out the all trays. See Fig. 1
4. By lifting up the humidifying pan cover, unhook it at the rear and remove the cover as shown in Fig. 2.
5. Take out the humidifying pan. See Fig. 3
6. Loosen and remove the screw fixing the clamp and remove the clamp. See Fig. 4 and Fig. 5.
7. Remove all tray supports on the right and left side by lifting up the front side. See Fig. 6.
33
Fig. 1
Fig. 4
89
Fig. 2
Fig. 5
Fig. 3
Fig. 6