Canon PowerShot G11 Service Manual page 67

<Note on Reassembling>
(1) Attach the LCD PCB ASS'Y and PLATE as shown in the figure below.
(2) Attach the HINGE UNIT as shown in the figure below.
Note on Reassembling (1)
LCD PCB ASS'Y
Rib
STEP 1
Insert the four ribs and
attach the LCD PCB ASS'Y.
Note on Reassembling (2)
e
STEP 1
Attach the HINGE UNIT with its concave
side facing downward.
DOUBLE-SIDED TAPE
STEP 3
Fold back the LCD INSULATION SHEET,
and then attach it with the DOUBLE-SIDED
TAPE.
Rib
STEP 2
Fix the PLATE, secure the LCD PCB ASS'Y, and
then connect the CN4301 and CN4302.
Concave section
HINGE UNIT
LCD
INSULATION
SHEET
15
CN4301
CN4302
Confirming the top face/back
face of the connector
Note that a mark is stamped on the top face.
Top face
Marker: Mark
STEP 2
Insert the CN4303. Simultaneously push both
ends of the connector with even force to
attach it.
Insert between
the FPC
and COVER.
PLATE
Back face
CN4303