<How to detach the Connector>
Detach the connector from the CN4001 by following the instructions shown below.
How to detach the Connector
Recommended slotted screwdriver
Procedures
1 Insert the tip of the slotted screwdriver straight into the gap between the connector and the
circuit board.
2
Alternately lift up the right and left sides of the connector little by little to detach it.
Note: In order to prevent the connector from being damaged, avoid detaching the
connector at one stroke.
Connector
Note: Do not insert the screwdriver tip into the
following positions.
NG
Do not insert into a
connector end (corner
portion of the connector)
* Other cautions
1. Do not lift up the connector by the cable as this may break the cable or
damage the connector.
2. Do not attach and detach the connector more than 30 times.
Thickness: 1.2 mm or less
Screwdriver
Do not insert obliquely.
NG
11
Width: 2 mm or more
2
Lift up the connector in
the vertical direction with
the tip of the screwdriver.
1
Insert the tip of the screwdriver into
the gap between the connector and
the circuit board.
Positions where the screwdriver tip
should be inserted
NG
Do not insert into a
connector side.