Subscribe to Our Youtube Channel
Related Manuals for Stevens AeroModel rockette 100
Summary of Contents for Stevens AeroModel rockette 100
- Page 1 Build Instructions Rockette (100) By Stevens AeroModel Length 16 inches | Span 22 inches | Area: 100 inches | Flying Weight 1.8 oz. Version 03/28/2011 © 2011 Stevens AeroModel all rights reserved.! Page 1 of 10...
-
Page 2: Build Instructions
Build Instructions WARRANTY Stevens AeroModel guarantees this kit to be free from defects in both material and workmanship at the date of purchase. This warranty does not cover any component parts damaged by use or modification. In no case shall Stevens AeroModel’s liability exceed the original cost of the purchased kit. Further, Stevens AeroModel reserves the right to change or modify this warranty without notice. -
Page 3: Kit Contents
☐ Heat Gun and Covering Iron ☐ Small Needle Nose Pliers ☐ 1/2 in. wide clear tape ☐ Servo mounting tape [DUB634 ☐ Soldering Iron ☐ Glass cleaner solution (Windex) © 2011 Stevens AeroModel all rights reserved.! Page 3 of 10... - Page 4 (use no glue) the parts together first. It’s advised to work 1-2 steps ahead in the instructions using this dry-fit technique which allows ample opportunity to inspect the fit and location of assembled © 2011 Stevens AeroModel all rights reserved.! Page 4 of 10...
- Page 5 F6 motor mount. Bond 8. Fit landing gear brace F8 to fuselage side F4. with CA glue. © 2011 Stevens AeroModel all rights reserved.! Page 5 of 10...
- Page 6 “W” followed by a numeric. the keel F16. Repeat this step for the Parts have been numbered so that the wing © 2011 Stevens AeroModel all rights reserved.! Page 6 of 10...
- Page 7 CA. image wing tip, and NOT two left wing tips! Building Tip: Turn plan over and place on a light colored surface - the back side of the © 2011 Stevens AeroModel all rights reserved.! Page 7 of 10...
-
Page 8: Final Assembly
63. Use a hot soldering iron or knife to open When satisfied that everything is true, final circular pockets immediately aft of rear former © 2011 Stevens AeroModel all rights reserved.! Page 8 of 10... - Page 9 79. Mount the propellor [EFL9051] on the motor. final product is often helpful at avoiding disaster. © 2011 Stevens AeroModel all rights reserved.! Page 9 of 10...
- Page 10 You may correspond with Stevens AeroModel staff using any of the ☐ Clear prop! Before applying power to the following methods: model, clear and keep clear of the prop arc.
Need help?
Do you have a question about the rockette 100 and is the answer not in the manual?
Questions and answers