Salus RT305TX Instruction Manual page 9

SETTING UP RF COMMUNICATION WITH
YOUR RECEIVER
RXRT505
(ONLY)
For full instructions on pairing the RXRT505 see page 7 of the receiver manual.
RXVBC605, RXWBC605,
RXBC605 & RXST625)
To enter learning mode press and hold
FROST key for 6 sec and the thermostat
will show SY9 (see below) once the
thermostat is in learning mode press and hold the sync button on the
receiver (see receiver manual for info) wait for the red LED on receiver to
stop flashing then press any key to cancel and return to the main screen.
RT305TX INSTRUCTION MANUAL
After you have switched the above receiver on, the
thermostat will automatically pair. When the red
LED stops flashing, the unit has successfully paired.
If you have difficulty in pairing the thermostat, we
recommend changing the address codes in the
thermostat and the receiver.
To adjust the RF address code of the receiver,
simply push up one or more of the 5 DIP switch
levers on the DIP switch bank located on the back
of the receiver (the levers are numbered 1 to 5
from bottom to top, as shown in the picture left),
and then make a note of the setting of each switch:
To adjust the RF address code of the thermostat,
remove one or more of the jumper caps located on
the back of the unit (labelled 1,2,3,4 and 5, and
shown in the picture left) so that the jumper
settings match the settings made on the receiver:
9