Door Disassembly; Noise Filter Removal - Viking DMOR200SS Service Manual

DMOR200SS
. Disconnect the power supply cord.
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for 60
seconds.
4. Remove the three (2) screws holding the hood exhaust
louver to the oven cavity front face plate.
5. Remove the hood exhaust louver from the oven cavity.
(Refer to the procedure of "HOOD EXHAUST LOUVER
REMOVAL".)
6. Remove door assembly, referring to "DOOR
REPLACEMENT".
Replacement of door components are as follows:
7. Place door assembly on a soft cloth with latches facing
up.
Note: As the engaging part of choke cover and door frame
are provided at 5 places, do not force any particular
part.
CHOKE COVER
8. Insert a putty knife (thickness of about 0.5mm) into the
gap A between the choke cover and door stopper and
between the choke cover and the door frame as shown
Figure C-3 to free engaging parts.
9. Pry the choke cover by inserting a putty knife in order
shown in Figure C-3.
0. N ow choke cover is free from door panel and door
frame.
NOTE: When carrying out any repair to the door, do
not bend or warp the slit choke (tabs on the
door panel assembly) to prevent microwave
leakage.
1. Disconnect the power supply cord and then remove the outer
case.
2. Open the door and block it.
3. Discharge the high voltage capacitor.
4. Disconnect the wire leads from the terminals of the noise
filter.

DOOR DISASSEMBLY

DOOR FRAME ASSEMBLY
. R emove two (2) screws holding the door panel to the
door frame assembly.
2. R elease the door panel from the door frame assembly.
NOTE: It is easier to release the engaging parts of the upper
3. N ow, door frame assembly is free.
LATCH SPRING, LATCH HEAD AND DOOR PANEL
4. R elease the latch spring from the tab of the latch head
and tab of the door frame.
5. R elease the latch head from the door frame.
6. N ow, the latch spring and latch head are free.

NOISE FILTER REMOVAL

5. Remove one screw mounted into the noise filter and fan duct.
6. The noise filter is now free.
34
or lower door hinge pin side at first.
A
Choke cover
Figure C-3. Door Disassembly
Door stopper
Putty knife
Door frame