Oven Diagram - Viking DMOR200SS Service Manual

Electrical Requirements
The oven is equipped with a 3-prong grounding plug. DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE
GROUNDING PIN FROM THE PLUG.
The power supply cord and plug must be connected to a separate 20 Volt AC, 60 Hz, 5 Amp. or more dedicated line,
using a grounded receptacle. The receptacle should be located inside the cabinet directly above the Microwave Oven/Hood
system mounting location.
14
2
6 1 13 4
1
2
3
4
5
6
7
8
9
10
11

OVEN DIAGRAM

12 14
7
8
9
10
11
3 5 6 17
Oven door with see-through
window
Door hinges
Waveguide cover
DO NOT REMOVE.
Turntable motor shaft
Oven light - on during operation
and when the door is open.
Safety door latches - door must
be securely closed for the oven
to operate.
Cook and time display
LIGHT Hi/Lo pad - controls
interior light
Press the LIGHT Hi/Lo pad once
for Hi. Press again for Lo. Press a
third time to turn the light o .
FAN Hi/Lo pad - controls fan
Press the FAN Hi/Lo pad once
for Hi. Press again for Lo. Press a
third time to turn the fan o .
Control panel
One touch DOOR OPEN
Push to open door
3-Pronged Plug
Grounded
Receptacle Box
Grounding Pin
3-Pronged Receptacle
18
15
16
19
12 Louver
13 Nameplate
14 Louver screws - remove
screws to replace
charcoal lter.
15 Removable turntable
- rotates clockwise or
counterclockwise
Only remove for cleaning
16 Removable turntable
support
1. Carefully place the
turntable support in
the motor shaft in the
center of the oven
oor.
2. Place the turntable on
the turntable support
securely.
17 Heat de ector
18 Light cover
19 Grease lters
7
DMOR200SS
(Front of Microwave)
Bottom of Unit
(Rear of Microwave)