Table of Contents
Advertisement
Automatic System Rearming
This feature, which can be turned on by your installer during the installation, insures the security of the system by protecting
your car in case of an accidental disarm.
If your system becomes disarmed due to an accidental press of the Disarm Button, the system will automatically rearm if no
other activity is detected within one minute.
One minute after Remote Disarming, the system will alert you with a series of chirps, then arm. (If the Passive Door Locking
feature is selected during the installation, the system will also relock the doors.)
Any of the following will cancel Automatic System Rearming:
• Turn on the ignition.
• Open the Trunk or Hood.
• Activate Auxiliary Function 1 or 2.
Automatic System Rearming is independent of Passive Arming and only takes place if the system was Armed (actively or
passively) for at least 10 seconds and then Disarmed by the Remote Transmitter.
Full Time System Diagnostics
The system continuously monitors all protected zones, even when it is not armed, and warns you if it detects a problem when
.
you turn off the ignition
1. Turn off the ignition.
2. If the siren chirps twice, the system has detected a problem.*
3. The status LED will flash to indicate the zone where the problem has been detected.
1 flash
=
door
3 flashes
=
hood / trunk
4 flashes
=
optional sensor
* The system must see the zone open or active for at least 20 seconds before the zone is determined to be defective. This
way, opening the car door before turning off the ignition will not cause the siren to emit the warning chirps.
Valet Mode
Allows you to temporarily disable the security system when the car is being service or turned over to a parking attendant.
To turn Valet Mode on or off:
1. Turn on the ignition.
2. Press and hold the override switch.
3. While holding the override switch, turn off the ignition.
• The siren will chirp once to indicate you have turned Valet Mode on.
• The siren will chirp twice to indicate you have turned Valet Mode off.
4. Release the override switch.
While Valet Mode is on, the LED will light solid and you can continue to lock and unlock your doors with the Remote
Transmitters, as well as operate the Auxiliary Functions.
For added protection, when the doors are locked using the Remote Transmitter, the siren will chirp twice, the system's Starter
Disable circuit will activate, and the LED will emit double flashes until the system is unlocked by the Remote.
If the Remote Transmitter is lost, stolen, or becomes inoperable while the car is locked in Valet Mode, you can exit the Valet
mode to deactivate the Starter Disable circuit.
Adding a New Transmitter into the System
Have all desired transmitters ready (up to 4 transmitters)
1. Turn on the ignition.
2. Press and hold the Override switch.
G1100 Installation Manual - Page 8
Advertisement
Table of Contents
