Table of Contents
Advertisement
• The status LED will turn on red.
• The siren will chirp 5 times.
3. Within 5 seconds follow the steps below for each transmitter:
Continue holding the Override switch and Press Transmitter Button 1 for remote arming with chirp confirmation.
--- or ---
Release the Override switch and Press Transmitter Button 1 for remote arming without chirp confirmation.
• The status LED will flash once quickly to confirm that the new Remote Transmitter has been added.
4. Turn off the ignition.
• The siren will chirp 3 times to confirm that the new Remote Transmitters have been added.
Deleting Transmitters (Adding a Remote Transmitter and Erasing All Other Transmitters From the System)
Code all memory locations to delete any lost transmitters. Example: if two transmitters are used, after coding the first
transmitter, code the second transmitter three times to fill up the remaining memory locations.
Page 9 - G1100 Installation Manual
Advertisement
Table of Contents
