Remote Disarming; Tamper Alert; Silent Arming / Disarming; Arming Mode Selection - Clarion Ungo MS2000 Owner's Manual

Clarion vehicle security system owner's manual
Table of Contents

Advertisement

To Bypass the sensors:
1. After arming the system, press Button 1 again on the Remote Transmitter within 5
seconds.
• The siren will chirp 5 times, indicating the sensors have been bypassed.
2. The sensors will remain bypassed until the next time the system is armed.

Remote Disarming

To Disarm the System:
Press Button 2.
• The siren/horn will chirp twice.*
• The doors will unlock.
• The parking lights will flash twice.**
• The LED will turn off.
* The siren chirps and light flashes during disarming will alert you if the system had been triggered while armed.
2 chirps / 2 flashes
3 chirps / 3 flashes
** If the Passenger Unlock Feature is installed, pressing Button 2 will unlock only the driver's door. Pressing the
unlock Button 2 again unlocks all doors.

Tamper Alert

On Disarming, if the system responds with three chirps, indicating the system was triggered, the
LED will flash for 60 seconds to indicate the zone that triggered the system.
LED Flashes (60 seconds):
1 flash
=
2 flashes
=
3 flashes
=
example: flash-flash-pause-flash-flash-pause = shock sensor
Note: Turning on the ignition will cancel Tamper Alert zone indications.

Silent Arming / Disarming

Each Remote Transmitter can be individually set to always Arm and Disarm the system with or
without chirp confirmation at the time they are programmed into the system (see Adding a New
Transmitter into the System).
To temporarily cancel the Arming and Disarming confirmation chirps, you can Arm or Disarm the
system by pressing Button 3.
Note: The confirmation chirps will only be cancelled if the system status is normal. The chirp indications for Tamper
Alert and the open zone warning will not be cancelled when the system is Armed or Disarmed silently .

Arming Mode Selection

Your system can be set in one of the following Arming Modes:
• Passive (automatic) Arming with chirp confirmation
• Active Arming (by Remote Only)
• Passive (automatic) Arming without chirp confirmation
=
normal disarming
=
Tamper Alert - system was triggered
door
shock sensor
trunk
MS2000 Owner's Manual - Page 5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents