Changing Exhaust Air Micro Filter; Cleaning - Fakir S 350 Instructions For Use Manual

Changing exhaust-air
micro-filter
37

Cleaning

Nach dem Gebrauch Nach dem Gebrauch After use Kapitel
1. Press the side release button [37] and open the filter co-
vering [F].
2. Remove the old exhaust-air micro-filter [38] and insert the
F
new one.
3. Re-insert the filter covering [F] precisely fitting and close it
until it engages.
NOTICE!
Change the exhaust-air micro-filter, at the latest, after the
consumption of 5 dust bags.
38
WARNING!
Switch the vacuum cleaner off and pull out the power plug
before you begin any cleaning and maintenance. This pre-
vents the device being switched on by mistake.
ATTENTION!
Do not use any cleaning agents, abrasives or alcohol. The-
se damage the casing.
Clean the device dry only or with a moist cloth.
You can also clean the filter enclosure with a moist cloth, as
required. Check vacuum accessories, such as hose, tubes
and nozzles, regularly for possible clogging and clean; whe-
re appropriate, rinse and dry.
If the device should not work satisfactorily (decreased sucti-
on capacity, unusual noises or failure), first check whether
the filters are full or clogged, and whether suction paths ha-
ve clogged up.
GB
47