Table of Contents
Advertisement
2.2 Getting Started
To power on the HG523, press the power button on the top of the HG523.
After you power on the HG523, the ADSL indicator blinks (for less than three minutes
which indicates that the HG523 is being activated. Later, the ADSL indicator turns
solid on. The POWER indicator is also solid on, which indicates that the HG523 is
working properly.
3 Setting the Network-Access Parameters
B y configuring the HG523 and your computer, you can choose any of the following
methods to surf the Internet:
Accessing the Network Through the Embedded PPP Dial-Up Software on the
HG523
Accessing the Network Through the PPP Dial-Up Software on Your Computer
3.1 Accessing the Network Through the
Embedded PPP Dial-Up Software on the HG523
If you select this method for accessing the network, the HG523 starts to
connection au
tomatically after the startup. You can access the network after you power
on your c
om uter. You do not need to install any special dial-up software on your
p
computer
or perform dial-up operations on your computer. To configure the HG523 and
your com
puter for the network access, do as follows:
Step 1
Log in to the Web-based configuration utility of the HG523.
1. Launch the Internet Explorer on your computer. Enter http://192.1
in the address bar, and then press En
2. In the displayed dialog box, enter the user name and the password, and
then click OK.
By defau
lt, both the user n
the passw
ord are verified, you can access the Web-based config
Step 2
Enable the embedded dial-up function.
1. In the navigation tree on the left of the Web-based configuration u
choose Basic > WAN.
2. Click New.
3. Select Enable check box for WAN c
4. Enter the VPI and VCI that are provided by the network operator in t
VPI/VCI text boxes.
5.
Select INTERNET from the Service list drop-down combo box.
ame and the password are
8
ter.
admin. After the user name and
uration utility.
onnection.
),
set up a dial-up
68.1.1
tility,
he
Advertisement
Table of Contents
