LifeFitness EXPLORE CONSOLE Operation Manual page 8

 WARNING:
ture. Therefore, the products cannot be stopped immediately.

Do not stand or sit on the rear plastic covers of the Cross-Trainer.

Do not stand on center tube of the Cross-Trainer.

The individual human power required to perform an exercise may be different than the mechanical power
displayed on the Cross-Trainer and FlexStrider.

Use caution when mounting or dismounting the Cross-Trainer and FlexStrider. Before mounting, use the mov-
ing arms to bring the pedal nearest to you to the lowest position. Use the stationary handlebars whenever ad-
ditional stability is required. While exercising, hold onto the moving arms.

Never face backward while using the Cross-Trainer or FlexStrider.
LIFECYCLE EXERCISE BIKES
 WARNING:
to any other objects and 2 ft. (0.6 m) in the direction the equipment is accessed from.

Do not stand or sit on plastic shrouds.

Use caution when mounting or dismounting the Lifecycle Exercise Bike. Use the stationary handlebar whenever
additional stability is required.
POWERMILL CLIMBER
 WARNING:
Climber and 1 ft. ( 0.3 m ) on each side.

Handrails may be held to enhance stability as needed, but are not for continuous use.

The product should never be left unattended when plugged in. Disconnect from the electrical outlet when not
in use, and before putting on or taking off parts. To disconnect, turn power OFF at the ON/OFF switch, then re-
move plug from electrical outlet.

Never walk or jog backwards on the PowerMill Climber.

Unlike bikes, cross-trainers, or the traditional paddle stairclimbers, this is a motorized product. This motorized
product causes stair steps to descend at variable rates and therefore operates on different planes simultane-
ously. While operating the product during a typical workout, the user is forced to fully concentrate on coordi-
nating his or her efforts on the moving stairs. Therefore, the user cannot see if anyone or any thing approaches
from the rear. For these reasons this unit is designed for use only in a controlled setting. The PowerMill
Climber is not designed for use in the home and should not be used in an environment where children
or animals might have access.

When it is necessary to immobilize the product, set the display to read SELECT WORKOUT. (Press the PAUSE /
STOP key twice if not already there.) Hold down the LEVEL DOWN arrow key and press the PAUSE / STOP key.
The product now displays "IMMOBILIZED". The product can't be operated in this state. The motor is disabled.
The product will remain in this state across resets, power cycles, etc. To restore normal operation, repeat the
same key sequence: hold down the LEVEL DOWN arrow key and press the PAUSE / STOP key. The product will
display "SELECT WORKOUT".
SAVE THESE INSTRUCTIONS FOR
The Cross-Trainer and FlexStrider are not equipped with a free-wheeling fea-
Provide at least 3 ft. (0.9 m) between the front or rear of the Life Fitness bike
Allow at least 3 ft. (1 m) of clearance behind the Life Fitness PowerMill
FUTURE REFERENCE.
7