Changing Battery - NIPRO Diagnostics TRUE METRIX Owner's Booklet

Changing Battery

A low battery displays Battery Symbol while
continuing to function. A dead battery
displays Battery Symbol, beeps, and then
turns off. To replace battery:
1. Lift tab on Battery Door.
2. Turn meter over, tap gently on the
palm of your other hand to loosen
and remove battery.
3. Discard old battery into
appropriate container.
4. Insert new battery, positive ("+")
side facing up. Close Battery Door.
Note: Use non-rechargeable 3V lithium battery (#CR2032).
5. Press " • " Button to turn meter on. Check time,
date, Ketone Test Alert and Test Reminders (see
Meter Set Up). If meter does not turn on, check that
battery was installed properly. If not, remove and
reinsert battery. Turn meter on by pressing " • "
Button. Call 1-800-803-6025 if problem persists.
Warning! Battery is not rechargeable. If you have a cable
or a cradle for downloading results to a computer, DO NOT
plug the usb cable end into an electrical outlet. Trying to
recharge the battery or power the meter by plugging into an
electrical outlet will cause meter to catch on fire or melt.
Caution!
Batteries might explode if mishandled or incorrectly
replaced. Do not dispose of battery in fire. Do not
take apart or attempt to recharge battery. Dispose
according to local regulations.
44
Low
Tab
Battery
Door