Changing Battery - NIPRO Diagnostics TRUEtrack Owner's Booklet

Changing Battery

Replace battery when Low or Dead
Battery Symbols appear in Display
or Meter does not turn on.
1. Lift tab on Battery Cover.
2. Turn Meter over, tap gently
to loosen and remove battery.
3. Insert new battery, positive
("+") side up. Close cover.
Note: Use non-rechargeable
3V lithium battery
(#CR2032).
4. Discard old battery in appropriate container.
5. Turn Meter on. If Meter will not turn on,
check that battery was installed properly. If
not, reinsert battery and try again. Call for
assistance if problem persists.
Caution!
Note: Replacing battery may affect date and time
settings. Check date and time by going to
Set Up and scrolling through the time/date
settings by pressing
Batteries might explode if mishandled or
incorrectly replaced. Do not dispose of battery
in fire. Do not disassemble or attempt to
recharge battery. Dispose according to local/
country specific regulations.
.
33
Low Dead