Table of Contents
Advertisement
EngliSh
16
Question
Why does the parent unit
react slowly to the baby's
crying?
Why do the batteries of
the baby unit run low
quickly?
Why does the charging
time of the parent unit
exceed 8 hours?
The specified operating
range of the baby monitor
is 300 meters/900 feet.
Why does my baby
monitor manage a much
smaller distance than that?
Why is the connection lost
every now and then? Why
are there sound
interruptions?
What happens during a
power failure?
Is my baby monitor secure
from eavesdropping and
interference?
Some buttons do not
seem to work when I
press them. What do I do
wrong?
The operating time of the
parent unit is supposed to
be at least 24 hours. Why
is the operating time of
my parent unit shorter?
Answer
The microphone sensitivity level of the baby unit may be set too low.
Increase the microphone sensitivity level with the SENSITIVITY
button on the parent unit.
The microphone sensitivity level of the baby unit may be set too
high, which causes the baby unit to transmit more often. Decrease
the microphone sensitivity level with the SENSITIVITY button on the
parent unit.
The volume on the baby unit may be set too high, which causes the
baby unit to consume a lot of energy. Decrease the volume of the
baby unit.
Perhaps you have turned on the nightlight. If you want to use the
nightlight, we advise you to run the baby unit from the power supply.
The parent unit may be turned on during charging. Turn off the
parent unit during charging.
The specified range is only valid outdoors in open air. Inside your
house, the operating range is limited by the number and type of
walls and/or ceilings in between. Inside the house, the operating
range is up to 50 meters/150 feet.
The baby unit and the parent unit are probably close to the outer
limits of the operating range. Try a different location or decrease the
distance between the units. Please note that it takes about 30
seconds each time before a connection between the units is
established.
If the parent unit is sufficiently charged, it continues to operate
during a power failure, both inside and outside the charger. If there
are batteries in the baby unit, it automatically switches to battery
operation in case of power failure.
The DECT technology of this baby monitor guarantees no
interference from other equipment and no eavesdropping.
You have to press all buttons (except the on/off buttons and the
TALK button) briefly. If you press them too long, they do not work.
When the parent unit batteries have been charged for the first time,
the operating time is less than 24 hours. The batteries only
reach their full capacity after you have charged and discharged
them at least four times.
The volume of the parent unit may be set too high, which causes the
parent unit to consume a lot of energy. Decrease the volume of the
parent unit
Advertisement
Table of Contents
