Table of Contents
Advertisement
10 Small plug
11 Battery compartment lid
12 Inlet for small plug
13 Battery compartment
Parent unit (2 pieces, only one is shown)
B
1
TALK button
2
LINK light
3
SENSITIVITY button
4
On/off button 3
5
Opening for belt clip and neck strap
6
Sound level lights
7
Volume +/– buttons
8
Battery check light T
9
Microphone
10 Loudspeaker
11 Battery compartment
12 Belt clip
13 Battery compartment lid
14 Neck strap
15 Adapter
16 Charger
17 POWER light
Travel pouch
C
Preparing for use
Baby unit
You can operate the baby unit directly from the power supply or on batteries. Even if you are going
to operate the unit from the power supply, we advise you to insert batteries. This guarantees
automatic back-up in case of power failure.
Corded operation
1
Put the small plug in the baby unit and put the adapter in a wall outlet (Fig. ).
Battery operation
The baby unit runs on four 1.5V R6 AA batteries (not included). We strongly advise you to use
Philips LR6 PowerLife batteries.
Make sure your hands and the unit are dry when you insert the batteries.
1
Turn the battery compartment lid to the left ( Á OPEN) with the palm of your hand. (Fig. )
Remove the lid.
Insert four 1.5V R6 AA batteries (Fig. ).
Place two batteries on top of each other and make sure the + and – poles of the batteries
,
point in the right direction.
Put the battery compartment lid back onto the unit and turn it to the right (CLOSE ª) with
the palm of your hand to close it. (Fig. 5)
Note: When the batteries are running low, the battery check light ( T) lights up red.
Parent unit
This appliance comes with two parent units and two chargers instead of one, so that your baby can
be monitored by two persons at the same time.
EngliSh
Advertisement
Table of Contents
