Cisco 2100 Series Configuration Manual page 31

Spectralink VIEW Certified Configuration Guide: Cisco Controllers and APs
2 In the navigation pane, under Access Points click Radios, then select 802.11a /n. All the
APs that are connected should be listed, showing their Operational Status as UP.
3 Select Configure from the drop-down list for the access point you wish to change. Set
the parameters for that AP:
Settings: Power and channel settings
Global settings for RF Channel Assignment and Tx Power Level Assignment
were not tested. For Custom Tx Power and RF Channel settings please consult
your facility's RF site survey — optimized for wireless voice traffic — to determine
correct power and channel settings for each AP using non-overlapping channels.
a Configure any other settings that might be relevant to your deployment as needed.
b Click the Apply button to save all changes.
721-1001-000-AH.docx
December 2016 31