VisionNet M505N User Manual page 63

Step 2: Configure the Port Forwarding Rule
2.A Choose the name of the rule
Choose the appropriate WAN
Interface:
If the Service you would like to
have is already available in the
"Select a Service"
select this service for auto-
population.
You may create a custom Service by
selecting "Custom
entering a new rule name
2.B Enter the port rules
This is the port that will be used to
External Port
access the device on the WAN Side
Start
External Port This should be the same as "External
End Port Start"
This should be "TCP/UDP" to avoid
Protocol possible errors due to end-user mis-
communication
This should be the port that the
Internal Port
device "listens" on (see IP Camera
Start
example)
External Port This should be the same as "Internal
End Port Start"
This should left blank, unless only
Remote IP one remote device, with a static IP,
will be allowed to access this port.
2.C Select "Save/Apply"
2.D Considerations
For this rule to work properly, the LAN device must have either a Static IP, or a Reserved IP
The LAN Device, and modem, may should be reset to ensure that this rule continues to work correctly
DQ Technology, Inc. / VisionNet
menu, you may
Service" and
Page 63 M505N User Manual Revision 3.2