VisionNet M505N User Manual page 25

Step 2: Configuring the WAN Interface
2.A Select the "WAN" tab located within the left-hand frameset.
VPI: ISP Specific
VCI: ISP Specific
ONLY Path0 Should be
DSL Latency
checked
EoA
IPOE/MER, PPPOE,
Bridged
Select DSL Link
PPPoA
IPoA
Default Mode
Standard (Single Service)
Select
Connection
VLAN MUX
Mode:
Multiple VLANs over a
single PVC
Encapsulation
ISP Specific
Mode:
Service
ISP Specific
Category:
Strict Policy
Standard for single
service config
Weighted Fair Queuing
Select ISP QoS
Use multiple service
configurations
IE: Data PVC – 1/8
IE: IPTV PVC – 1/1
2.B Select "Apply Save"
You will see the Interface
reflected in the updated
Interface Table
DQ Technology, Inc. / VisionNet Page 25 M505N User Manual Revision 3.2