VisionNet M505N User Manual page 34

Step 2: Configuring the WAN Service
2.A WAN SERVICE CONFIGURATION.
Select WAN
Service Type:
Enter Service
Description
802.1P Tag
(Only
for VLAN Mux
Services)
802.1Q Tag
(Only
for VLAN Mux
Services)
2.B Select "Next"
PPP Username Enter unique Username
Enter unique Password
PPP Password
Leave blank unless specified
PPPoE Service
by your Network Ops
Name
Manager
AUTO unless specified by
Authentication
your Network Operations
Method
Manager
1492 unless specified by
MTU your Network Operations
Manager
Enabled, unless otherwise
Enable NAT specified by Network
Operations
Disabled, unless specified
Enable Full-Cone
otherwise by Network
NAT
Operations
Disabled unless specified
Dial on Demand otherwise by Network
Operations
Disabled unless specified
PPPIP Extension otherwise by Network
Operations
Use Static IPv4 Only use for static IP
Address Settings
Disabled – this is only for
Enable PPP sending PPP packets to the
Debug Mode Syslog for temporary
troubleshooting
Disabled – this will allow
Bridge PPPoE Clients to tunnel through
Frames the firewall to create a
second PPPoE Session
Disabled unless specified
MultiCast Proxy otherwise by Network
Operations
2.C Routing – Default Gateway
DQ Technology, Inc. / VisionNet
PPPoE
Will not affect service – no
spaces allowed
-1 Untagged
Otherwise, choose appropriate
tag
-1 Untagged
Otherwise, choose appropriate
tag
and Proceed to "PPPoE Username and Password"
Page 34 M505N User Manual Revision 3.2