Electrolux EKI6450AO User Manual page 32

32 www.electrolux.com
The appliance does not
operate
The appliance does not
operate
The appliance does not
operate
The appliance does not
operate
The oven does not heat
up
The oven lamp does not
operate
Steam and condensation
settle on the food and in
the oven cavity
The display shows
"12.00" and "LED"
The residual heat indica-
tors does not come on
The cooking zone re-
duces the heat setting to
A sound operates when
the appliance is off
Heat setting alternates
A sound operates and
appliance starts and
stops again. After 5 sec-
onds one more sound
operates
comes on
comes on
comes on
comes on
Problem Possible cause
You touched 2 or more
sensor fields at the same
time
There is water or fat
stains on the control pan-
el
The child safety device or
key lock or operates
The appliance is not
switched on
The necessary settings
are not set
The oven lamp is defec-
tive
You left the dish in the
oven for too long
A power cut
The cooking zone is not
hot because it operated
only for a short time
You covered one or more
sensor fields or there is
water or fat stains on the
control panel.
You covered one or more
sensor fields
The Power management
is active
You covered
The automatic switch-off
operates
Overheating protection
for the cooking zone op-
erates
No cookware on the
cooking zone
Not correct cookware
Remedy
Only touch one sensor
field
Clean the control panel
See the chapter "Operat-
ing the appliance".
Switch on the appliance
Control the settings
Replace the oven lamp
Do not leave the dishes in
the oven for longer than
15-20 minutes after the
cooking process ends
Reset the clock
If the cooking zone must
be hot, speak to the after
sales service
Uncover the sensor fields.
Clean the control panel
Uncover the sensor fields.
See the section Power
management
Uncover the sensor field
Stop the appliance and
start it again
Switch off the cooking
zone. Switch on the
cooking zone again
Put cookware on the
cooking zone
Use the correct cookware