Symbology; Applied Standards; Use And Storing Of The Installation And Maintenance Manual - Jolly Mec STILE Installation, Use And Maintenance Manual

01.3

SYMBOLOGY

In this manual, points of considerable importance are marked with
the following symbology:
INSTRUCTION: Instructions regarding the correct use of
the heating system.
WARNING: This point is particularly important.
DANGER: An important point regarding behaviour for
preventing injury and damage to materials is expressed.
01.4

APPLIED STANDARDS

JOLLY MEC products are constructed according to directives:
• 89/106 CEE: Constructed products
• 2006/42/CE: Machines.
• 2014/30/UE: Electromagnetic compatibility.
• 2014/35/UE: Low voltage - electrical safety.
And in compliance with the standards:
• EN 60335.1: Safety of household electrical appliances and
similar products.
Part 1: General safety regulations
Part 2: Section 102. Special regulations for appliances fitted
with gas, diesel or solid fuel burners and electrical connections.
• CEI EN 50165: Safety of household non-electrical appliances
and similar products.
• CEI EN 61000: Electromagnetic compatibility (EMC).
Part 3: Limit values. Section 2 Limits for harmonic current emis-
sions (for appliance with current = 16 A per phase).
Part 3: Limit values. Section 3 Limitation of voltage fluctuations
and flickers for low voltage equipment with current = 16 A.
• UNI EN ISO 12100: Machine safety.
• CEI EN 50366: Electromagnetic fields.
• UNI EN 1443: Fireplaces - General requisites.
• UNI EN 1856-1-2: Fireplaces - Requirements for metal firepla-
ces.
• UNI EN 14785: Appliances for heating of homes using wooden
pellets - Requirements and test methods.
• UNI EN 13384: Fireplaces - Thermal calculations and dynamic
fluid.
• UNI 10683: Heat generators operating with wood or other solid
bio fuels - Installation requirements
• UNI 10412-2: Hot water heating system - Safety requirements
- Part 2.
• EN 55041: Electromagnetic Compatibility - Prescriptions for
white goods, electrical tools and similar appliances
Part 1: Release
Part 2: Immunity
• EN 62233: Measurement methods for electromagnetic fields of
electrical appliances for home use and similar goods regarding
human exposure.
In order to properly verify and calculate the requi-
rements of the areas to be heated, rely on thermo
technical personnel who will be able to establish the
necessary values according to the regulations in force.
RESPONSIBILITY:
Upon the delivery of this manual, JOLLY MEC S.p.A. de-
clines all responsibility, whether civil or criminal, for accidents due to
partial or total non-compliance with the specifications herein contained.
4
01.5 USE AND STORING OF THE INSTALLA-
TION AND MAINTENANCE MANUAL
• Recipients of the manual
The use and installation manual is addressed to users responsible
for the installation, operation and maintenance of the stove; parti-
cular attention must be given the parts of the manual concerning
safety.
• Scope of the manual
The manual contains information on the correct use of the product
in accordance with the purposes for which it was designed and
built. It also provides information about loads, commissioning, re-
pair and maintenance of the stove in conformance with the limits
set down by the manufacturer.
• Conservation of the manual
The installation and maintenance manual is an integral part of the
product and must be conserved up to the time when the stove is
dismantled. It must be kept in a protected, dry place out of direct
sunlight and near the product so that it is always readily available
for consultation. Should the manual get damaged, the user must
request a copy from the retailer where he purchased the ap-
pliance. When requesting assistance, always make reference to
the MODEL, LOT and SERIAL NUMBER indicated on the label
shown in CHAP.04.2.
• Updating the manual
The installation and maintenance manual reflects the status of the
technology at the time the product was marketed. The manufactu-
rer reserves the right to make modifications to the product, and
consequently the relative manual, without any obligation to update
previous editions. The user may at any time request information
and updates, which, when issued, will become integral parts of
the installation and maintenance manual. If the product is subse-
quently resold, the user is requested to hand over the manual and
to inform the manufacturer of the name of the new owner, so that
the latter may receive any updates issued.
• Cases in which the manufacturer is released from liability
The manufacturer is released from all liability in the following
cases:
a) improper use of the product.
b) use not intended by specific national regulations.
c) incorrect installation.
d) faults in the electrical connections, the connections of the fume
exhaust system and/or the comburent air ducting system.
e) failure to carry out maintenance as prescribed in this manual.
f) unauthorised modifications or operations.
g) use of replacement parts that are non-original or not specific to
the model.
h) total or partial failure to follow the instructions.
i) exceptional events (e.g.: breakages due to natural or accidental
events: lightening, short circuits etc.).
j) damage caused by electrical power cuts, sudden fluctuation of
supply voltage, electromagnetic fields.
k) use of fuel with characteristics other than those recommended
in this manual *.
In the above cases the warranty is void.
*NOTE: In the event of a malfunction or intervention request
by a specialised Technical Service Center, the user must be
able to demonstrate the use of fuel with the characteristics re-
quired by this manual. The Manufacturer disclaims all liability
concerning anomalies or malfunctions caused by use of FUEL
which does not comply with the recommended requirements.