Jolly Mec STILE Installation, Use And Maintenance Manual page 23

PELLET loading auger gear motor, the icon is signalled by the DGT when the component is running.
Fume Extractor Fan, the icon is signalled by the DGT when the component is running.
V1 main air exchanger fan, the icon is signalled by the DGT when the component is running.
Alarm, the icon is signalled by the DGT when an alarm is triggered.
Starting up the stove:
WARNING!
The stove and firebox MUST ALWAYS be cleaned before starting up the stove, to avoid failed or difficult start up due
to residual unburned residue inside the firebox from previous use.
Press button 3 to start up the stove; the start up phases are as follows:
1) Initial ventilation;
to change the air inside the combustion chamber; the fume extractor fan and the electric heating element are the components running
during this phase.
2) Spark plug preheating;
when the initial ventilation has been completed, the fume fan stops whilst the electric heating element continues to run to perform the
start up preheating phase.
3) PELLET preloading;
after the preheating phase, a set amount of PELLETS are delivered to the firebox to ignite the first flame.
4) Flame standby;
the fourth phase is a standby time required to heat the preloaded PELLETS and wait for ignition.
5) Start up time;
when the flame is ignited, the electronic control unit starts up, where the fume temperature must reach a preset value in order for the
stove to start up.
6) Flame present;
after ignition, the electronic control unit activates another flame stabilisation standby time to allow all the PELLETS fed to the firebox time
to ignite before the actual heating phase (WORK)
• Display settings:
The LCD Display is divided into 4 rows.
The first from the top, is the space designated to displaying the settings, time, temperature, output and operating parameters.
The second row indicates the ambient temperature with the set output level next to it.
The third and fourth row display stove operating messages, occupying both rows or just the fourth one, according to the length of the
message.
10:30
25°C P3
XXX
10:30
25°C P3
XXX
Example of display message with the stove OFF.
XXX = OFF
Example of display message with the stove ON.
XXX = ON
23