Folding Procedure - Lippe Lift LL12 Operation Manual

4.5.1

Folding procedure

In the case of the LL12 platform the base folds up and down electrically and the
safety barriers raise and lower electrically. This is performed by means of an UP or
DOWN command issued from a station (see also paragraph 4.5), or via the internal
controller in the case of special version 2. The control button must be pressed and
held (so-called jogging mode) until the folding procedure is complete.
If a malfunction should occur during the folding procedure, the platform must be
folded up or opened manually (see below) and customer service must be informed.
The folding procedure at a step can/may only be carried out by an attendant.
Proceed as follows in order to fold up the platform by hand:
a) Place the safety barriers in the horizontal position.
b) Fold up the base of the platform.
c) Lower the safety barriers so that they rest against the base of the platform.
Proceed in the reverse order to open the platform again and finally raise the safety
barrier at the desired access point right up to the top (vertical).
Operating manual LL12 12/18 Version 1.6 (01/2017)