Fetching And Sending The Platform Lift - Lippe Lift LL12 Operation Manual

4.5 Fetching and sending the platform lift (standard version)
Before each journey, make sure that the acoustic warning signal works. The LL12
platform lift can be fetched from or sent to another station from any station. To do
this, the key switch must be inserted at the respective station, turned in the
appropriate direction and held in this position.
The platform lift does not react immediately, but after a delay time of approx. 2
seconds.
Note: The platform lift drives from the external control point only in the folded up
condition, i.e. the base of the platform must be folded up and the safety
barriers folded downwards.
Note: an LED is mounted on the radio transmitter for fetching/sending the chair lift.
GREEN:
ORANGE: the battery power is diminishing; renew the batteries at your earliest
RED:
Fetching and sending the platform lift (special version 1) [via the external control
unit, only with 3-position key switch (p.7, item 2) for a trip with the platform open
via the external control unit]. This option must be activated by a specialist inside the
controller. It must be ensured that no third person can suddenly get/jump into the
path of the lift. Condition: driving area is 100% in view !!!!
The key switch (p.7, item 2) is to be set to position -II-, otherwise as in 4.5.
Fetching and sending the platform lift (special version 2) [via the internal
controller, only with 3-position key switch (p.7, item 2)]. This option must be
activated by a specialist inside the controller.
The platform can be driven via the internal controller in the folded up condition. The
key switch (p.7, item 2) is to be set to position -II- in order to do this. The platform
lift can now be driven via the internal controller (p.7, item 1).
Operating manual LL12
batteries are OK
convenience
the battery power is very low; replace the batteries immediately
11/18 Version 1.6 (01/2017)