11.
Tripping lever
05.02
In needle rise position, the flattened pin of control lever
the track of control cam
Fig. 11 - 18
Screw out screw
Loosen screws
Bring the needle bar to needle rise position by turning the handwheel.
Bring clamp
Keeping this position, move control lever
and then press control lever
In this position, tighten screw .
Carry out a check in accordance with the
Screw
when activating lever
and swing out connecting rod .
and .
to rest on the right side of the housing.
onto the bottom of the cam track.
remains loosened until the release trip is adjusted.
(see arrow) must fall slightly into
is activated.
laterally in accordance with the
11 - 21