Thread Check Spring - Pfaff 1245 Instruction Manual

11.

Thread check spring

04.14
11 - 16
The movement of thread check spring
material (approx.
Due to technical reasons, the length of the thread-check spring path can vary a
little in either direction.
Fig. 11 - 14
Thread the machine, place test material under the presser foot and allow the presser
foot to rest on the fabric using the presser foot lifter.
Loosen screw .
Sew a few stitches by turning the handwheel and then bring the take-up lever to its TDC.
Continue to turn the handwheel (in its direction of rotation) until the needle enters the
material.
In this position, bring stop
must be finished when the needle point enters the
spring path).
to rest on thread check spring and tighten screw .