Toshiba Satellite U300 Maintenance Manual page 210

Replacement Procedures
Installing the display assembly
The following describes the procedure for installing the display assembly (See Figure 4-13 to
4-17).
1. Inserting the pole of hinge to the hole of hinge assembly, set the display assembly
2. Secure the hinges with the following screws secure the display mask with the
NOTE: Be sure to apply the locktight to the screws instructed in the figure above.
3. Connect the LCD harness to the connector on the system board.
4. Arrange the wireless antenna cables along the guide (front) and secure them with
5. Pass the cables to the back of computer through the slot.
6. Arrange the wireless LAN antenna along the guide and contact with the connector.
7. Install the LAN board and cover ASSY of the system.
Satellite U300 and Satellite Pro U300 Maintenance Manual (960-Q08)
Downloaded from www.Manualslib.com
on the base assembly.
following screws and stick the mask seal on them.
• M2.5×5.0B
guide.
manuals search engine
FLAT BIND screw
(Locktight)
x2
4-33