Replacement Procedures
4.8
NOTE: Do not apply excessive force to the top of an optical disk drive.
Removing an optical disk drive
The following describes the procedure for removing an optical disk drive (See Figure 4-
11and 4-12).
1. Remove Keyboard and next remove the following screws securing an optical disk
2. Disconnect an optical disk drive toward the arrow direction from the connector
Satellite U300 and Satellite Pro U300 Maintenance Manual (960-Q08)
Downloaded from
www.Manualslib.com
Optical disk drive
Do not touch the shaded portion of the figure below, when the drive is removed
or installed.
drive.
•
M2.0×6.0B
CN26 on the system board.
Figure 4-11 Removing an optical disk drive
manuals search engine
FLAT BIND screw
x1
4-25