Epson p10000 User Manual page 152

5. Insert the new cartridge with the arrow facing up and push it in until it clicks into place.
Caution: Do not remove and re-insert cartridges more often than necessary. Doing so can break the
needle valve seal and allow air to enter the ink tubes, damaging the nozzles.
Note: Shake ink cartridges every 3 months after installation.
6. Close the ink cartridge cover.
Your product begins charging the ink delivery system. Do not turn off the product during ink charging.
Caution: If you remove an ink cartridge for later use, protect the ink supply area from dirt and dust and
store it in the same environment as the printer. The valve in the ink supply port is designed to contain
any excess ink, but do not touch the ink supply port or surrounding area. Always store ink cartridges with
the label facing up; do not store cartridges upside-down.
Note: If a cleaning cycle starts when the printer is in a "Ink Low" status and the level of ink is less than
that required for a cleaning,you see a prompt telling you that there is not enough ink to clean the print
head. Install a full cartridge to complete the cleaning cycle. At the end you can reinstall the original
cartridge.
Parent topic: Replacing Ink Cartridges
152