3.6
Graphic Card & Fan Duct Installation (option)
1.
Upside down the device first on a flat and clear floor.
2.
If necessary, please remove all the screws (number 1, 2, & 3) at the bottom side
including stand rubbers or mounting brackets.
3.
Carefully lift up the bottom case (number 4).
4.
First check whether the graphic card bracket size is long or not. If not, please
change to the long size with 2 screws (number 7).
5.
Insert the graphic card into the slot at the bottom case.
6.
Exactly check all the outputs location of the graphic card, and tighten 1 screw
(number 5) at the side.
7.
Carefully attach a fan duct on T mark on the bottom case following the right
directions with below photos.
8.
Carefully put the bottom case down and make sure to cover the whole device,
then tighten all the screws (number 1, 2, & 3) back.
Figure 3.5 Graphic card installation
21
DS-980/DS-980GL User Manual