Table of Contents
Advertisement
3.5
2.5-inch SATA SSD Installation (Bottom Layer)
1.
Upside down the device first on a flat and clear floor.
2.
If necessary, please remove all the screws (number 1, 2, & 3) at the bottom side
including stand rubbers or mounting brackets.
3.
Carefully lift up the bottom case (number 4).
4.
2.5-inch SATA module installation
4.1. Gently insert 4 yellow rubbers (number 5) into the storage tray.
4.2. Install 2.5-inch SATA on this storage tray (number 6) by 4 step screws
(number 7) from the side.
5.
Make sure to connect SATA cable and SATA power cable with 2.5-inch SATA
SSD and flatly install this SATA module by 4 screws (number 8). Properly place
both cables behind the nuts and keep a clear look.
6.
Carefully put the bottom case down and make sure to cover the whole device,
then tighten all the screws (number 1, 2, & 3) back.
Figure 3.4 2.5-inch SATA SSD installation (bottom layer)
DS-980/DS-980GL User Manual
20
Advertisement
Table of Contents
