Installing Display Assembly-With Touch; Removing Display Bezel - Dell Latitude 7280 Owner's Manual

Installing display assembly—with touch
1 Install the display assembly to align it with the display hinge holders on the system.
2 Tighten the M2.5 x 4.0 screws to secure the display hinges on the system display assembly with the system unit.
3 Route the eDP cable through the routing channel.
4 Connect the eDP cable to the connector on the system board.
5 Install the eDP metal bracket on the eDP cable and tighten the M2.0 x 5.0 screws.
6 Route the WLAN and WWAN cables through the routing channels.
7 Install the:
a WLAN card
b WWAN card
c battery
d base cover
8 Follow the procedure in

Removing display bezel

NOTE: The display bezel is available only for non-touch systems.
1 Follow the procedure in
2 Remove the:
28 Removing and installing components
After working inside your computer.
Before working inside your computer.