Installing WLAN card
1
Insert the WLAN card into the connector on the system board.
2
Connect the WLAN cables to the connectors on the WLAN card.
3
Place the metal bracket and tighten the M2.0 x 3.0 screw to secure it to the computer.
4
Install the:
a
battery
NOTE:
b
base cover
5
Follow the procedure in
Memory module
Removing memory module
1
Follow the procedure in
2
Remove the:
a
base cover
b
battery
NOTE:
3
To remove the memory module:
a
Pull the clips securing the memory module until the module snaps-out [1].
b Remove the memory module from the connector on the system board [2[.
18
Removing and installing components
If you have not removed the battery, you must connect the battery cable to the system board.
After working iinside your
computer.
Before working inside your
You need not remove the battery but instead disconnect the battery cable from the system board.
computer.