Table of Contents
Advertisement
Départ. Technical support- CM640
PHILIPS Consumer
Communications
Centre du Mans
6.0
TEST AND INSPECTION PLAN
The test plan is derived from the Product Test Reference of FISIO 820 and FISIO 825.
6.1
User Interface Test
Use the Test SIM Card to test the transceivers as follows :
With a fast Charger connected with the PRODUCT's bottom connector , check the full scrolling from one mode to
the next when charging IGN (Ignition) – Battery.
6.2
RF Test
The purpose of the radio test is to prove that the tested phone is compliant to the Standard.
The radio test must be performed with a
Digital Radio Test Set. The mobile has to
be set on the antenna coupler inside the
shielded chamber.
PHILIPS ELECTRONICS N.V. 1999
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
PROCEDURE
•
On/Off button
•
LCD Backlight
•
Keyboard Test
•
Buzzer Test
•
Vibrator Test
•
Audio Test
•
Antenna
Test ( to measure the radiated power level. Not necessary when using an antenna coupler)
•
LCD
•
IMEI
•
Tester Status/Eeprom Status
Service Repair Support
Or It can be tested using the product
cradle (in this case a measurement of
the power radiated by the antenna has
to be performed)
COMPANY RESTRICTED
VY-V-640-82x
Page : 6 of 71
Langue : EN
Date : 25/02/03
VY-V-640-82x
Advertisement
Table of Contents
