Test And Inspection Plan; User Interface Test; Rf Test - Philips 330 Service Manual

Depart. Technical support- CM640
PHILIPS Consumer
Communications
Centre du Mans
6.0

TEST AND INSPECTION PLAN

The test plan is derived from the Product Test Reference of PHILIPS 330.
6.1

User Interface Test

Use the Test SIM Card to test the transceivers as follows :
With a fast Charger connected with the PRODUCT's bottom connector, check the full scrolling
from one mode to the next when charging IGN (Ignition) – Battery.
6.2

RF Test

The purpose of the radio test is to prove that the tested phone is compliant to the Standard.
The radio test must be performed with a
Digital Radio Test Set. The mobile has to
be set on the antenna coupler inside the
shielded chamber.
Use the Test SIM Card « SP »to test the GSM 900 / DCS 1800 band
 PHILIPS ELECTRONICS N.V. 1999
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
PROCEDURE
• On/Off button
• LCD Backlight
• Keyboard Test
• Side Keys
• Buzzer Test
• Vibrator Test
• Audio Test
• Antenna
Test ( to measure the radiated power level. Not necessary when using an antenna coupler)
• LCD
• IMEI
• Tester Status/Eeprom Status
Service Repair Support
COMPANY RESTRICTED
VY-V-640-P330
Page : 5 of 43
Langue : EN
Date : 11/06/03
VY-V-640-P330