Table of Contents
Advertisement
Départ. Technical support- CM640
PHILIPS Consumer
Communications
Centre du Mans
6.0
TEST AND INSPECTION PLAN
The test plan is derived from the Product Test Reference of FISIO 620 and FISIO 625.
6.1
User Interface Test
Use the Test SIM Card « SP »/ Production to test the transceivers as follows :
With a fast Charger connected with the PRODUCT's bottom connector, check the full scrolling from one mode to
the next when charging IGN (Ignition) – Battery.
6.2
RF Test
The radio test must be performed with a Digital Radio Test Set. The mobile has to be set on the antenna coupler
inside the shielded chamber.
PHILIPS ELECTRONICS N.V. 1999
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
PROCEDURE
•
On/Off button
•
LCD Backlight
•
Keyboard Test
•
Buzzer Test
•
Vibrator Test
•
Audio Test
•
Antenna
Test ( to measure the radiated power level. Not necessary when using an antenna coupler)
•
LCD
•
IMEI
•
Tester Status/Eeprom Status
Service Repair Support
COMPANY RESTRICTED
VY-V-640-620-3
Page : 5 of 63
Language : EN
Date : 11/02/03
VY-V-640-620-3
Advertisement
Table of Contents
