Values For Requested-Attributes - HP 9000 User Manual

Specifies the attributes for which values are to be
-r
returned. This flag is equivalent to using the
command-attribute requested-attributes.
Refer to "Values for requested-attributes" in the
next section for a description of the use of this
command-attribute and flag.
Specifies the style or format in which the attribute
-s
values are to be displayed. This flag is equivalent to
using the command-attribute style. Refer to
"Style" later for a description of this command-
attribute and flag.
• In addition to pdls and pdq, the commands you use to create objects
and to modify the values for objects can also be used to request that a
limited set of attribute values be returned. The command-attributes
discussed within this section are supported by the following
commands:
For all objects: pdls, pdcreate, and pdset
For job and document objects: pdq, pdpr, and pdmod

Values for requested-attributes

To list the attribute values for requested-attributes, use either the
-r flag, the command-attribute requested-attributes, or a
combination of both. For example, using the -r flag to request all
attributes for a printer LogPrt1, enter:
pdls -c printer -r all LogPrt1
Using the command-attribute, you would enter:
pdls -c printer requested-attributes=all LogPrt1
Chapter 3
Command Reference
Command Syntax
61