Table of Contents
Advertisement
Service Mode
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
LAMP
MORE...
Select with é or ê
then <ENTER>
<EXIT> to return.
SERVICE
BARCO LOGO
PRESET INPUT BALANCE
ADD INS
I2C DIAGNOSIS
MORE...
Select with é or ê
then <ENTER>
<EXIT> to return.
Identification
How to display the Identification screen ?
1
Push the cursor key é or ê to highlight 'Identification' (menu 1).
2
Press ENTER to display the Identification screen (menu 2.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
LAMP
MORE...
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
The information
The following information is available on the identification screen:
- type of projector
- projector address
- software version
- installation configuration
- baud rate
- text ON
- projector serial number
- projector run time
Detailed description
- type of projector : BARCOELM G10
- software version
- Proj. Address : to change the address of the projector, see Change Projector Address in this chapter.
- Installation : possible installations :
To change the installation configuration, follow the instructions in chapter 'Installation Guidelines'.
- Baud rate : transfer speed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must be the
same as the baud rate of the connected computer. When there is a difference, consult 'Change Baudrate PC' in this chapter.
9-2
Downloaded From projector-manual.com Barco Manuals
PRESET INPUT BALANCE
WHITE BALANCE
BLACK BALANCE
DEFAULT
Select with <ENTER>
<EXIT> to return
Adjust
red with é or ê
blue with è or ç
ADD-INS
LIGHT SENSOR : [INACTIVE]
Select with é or ê
<ENTER> to toggle/select
<EXIT> to return.
BARCO
ELM G10
Proj. address : 001
Soft. version : 3.0
Config : front/
ceiling
Baudrate PC : 9600
text : ON
Serial no.: 1010200
Run time : 100 h
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 2
* Front/Ceiling
* Front/Table
* Rear/Ceiling
* Rear/Table
BARCO LOGO
STATUS : [ON]
BACKGROUND : [ON]
SHIFT
HOT KEY : [TEXT]
Select with é or ê
<ENTER> to toggle/select
<EXIT> to return.
I2C DIAGNOSIS
D C A
DECODER
12H # # #
MOTOR DRIVER
1AH # # #
LIGHT SENSOR
1CH # # #
LAMP DRIVER
20H # # #
LAMP DRIVER
22H # # #
POWER SUPPLY
30H # # #
INPUT SELECTOR
46H # # #
PMP INPUT SELECTOR
4AH # # #
INPUT SELECTOR
7EH # # #
LAMP MODULE
A0H # # #
Scroll with é or ê
<EXIT> to return.
5976070 BARCOELM G10 05052000
Advertisement
Table of Contents
