Omnivision PVQ-130W Service Manual page 76

2. Installation of Holder Unit
A. Turn the Wiper Arm Unit so that the grooves on each end are aligned with the
each groove on Side Plate L and R.
B. Insert Holder Unit boss (A) and (B) into the grooves as shown in Fig. K1-1.
C. Finally, in theEJECT Position, confirm that the protrudence on the Wiper Arm
Unit is aligned with the indentation on the Drive Rack Unit.
3. Make sure to hook the spring to the Drive Rack Arm of Mechanism chassis.
6.3.2. Opener Lever and Drive Rack Unit
Fig. K1-3
Fig. K2
76